How to eliminate the safety hazards of xenon lamp test chamber?

xenon lamp test chamber is an expensive instrument and equipment, its installation and use need to be strictly in accordance with the specifications to operate, xenon lamp test chamber will have what safety hazards?

How to eliminate the xenon lamp test chamber safety hazards?

xenon lamp test chamber has the following safety protection systems.

1. refrigeration system: leak detection test, compressor overheating, compressor overpressure;

2. Humidification system: heating tube dry burn, abnormal water supply, water shortage alarm;

3. Circuit system: over temperature protection, fan motor overheating, overall equipment under phase / reverse phase, overall equipment timing, leakage protection, overload and short circuit protection.

When installing the xenon lamp test chamber, pay attention to the following points to ensure personal safety:

1. Power supply: The power supply of the equipment uses a three-phase five-wire system, and the equipment cable is four-core wire, three phase wires, and one neutral wire. Please pay attention to the distinction between neutral wires. Because part of the load and control system of the equipment is single-phase, connecting the wrong zero line will cause the equipment to not work and be damaged. The wrong connection of the neutral and ground wires will cause the equipment to work abnormally. The cable needs to be extended due to factors such as the user's site. Please ensure that the rated parameters of the extension cable and power supply used can meet the power requirements of the product.

2. Site: A lot of heat will be generated during the use of the device. Please use the device in a well-ventilated place. Do not use the device near flammable materials or in an explosive environment. Do not use it in a strong magnetic field and strong vibration environment.

3. If the xenon lamp test chamber is not in an abnormal condition during the whole process of use, it is not necessary to open the tailgate of the environmental test chamber to prevent the occurrence of poor problems.

4. When installing the xenon lamp test chamber, it must be determined that the equipment is properly grounded to prevent electrostatic induction.

5. Show the safety maintenance of the test product and the operator, and please regularly maintain the pressure control panel and the water level line of the water storage tank of the circulation system.

6. The installation site should take into account the heat dissipation of the heat pipe of the xenon lamp test chamber and the parts that are easy to inspect and repair: for example, the installation site of the xenon lamp test chamber must be about 65 cm away from the opposite wall or equipment, and it must be installed in a place with good natural ventilation. , a site without a high temperature heat source.

QINSUN instruments have quality control. We select high-quality spare parts and have undergone repeated tests. In addition to the real and reliable natural environment and climate of your test site, we manufacture and produce reliable xenon lamp test chambers to ensure your safety.

2022-09-07 10:18