12 UV Accelerated Weathering Tester Maintenance Tips

UV Accelerated Weathering Tester is also well known as UV test chamber, which is a type of environmental test chamber using the fluorescent UV as the light source to determine the resistance of plastics, leathers, rubbers, fabrics, etc. to weathering under the specified conditions .

In order to make the UV Accelerated Weathering Tester work better and keep it in good condition for a long time, please maintain it according to the following items:

1. If the UV Accelerated Weathering Tester is not working, keep it dry and disconnect the power supply.

2. After the test, drain the water in the tester, and dry the studio and the box.

3. After use, remember to put the plastic cover on to avoid dust intrusion. If there is dust, it should be removed in time.

4. The sensing device in the studio should not be subjected to strong impact;

5. The UV Accelerated Weathering Tester should be placed in a well-ventilated place (it is recommended to install a ventilation fan to maintain indoor ventilation), and should not be installed in a dusty place;

6. When the failure of the ultraviolet light aging test box cannot be ruled out by yourself, please find the personnel of the ring instrument, and do not disassemble and assemble without permission;

7. If the test chamber is not used for a long time, it is necessary to carefully check the water source, power supply and various components when using it again, and then start the UV Accelerated Weathering Tester after confirming that it is correct;

8. Operators should wear protective goggles and sheaths. Because ultraviolet radiation has strong hazards to personnel (especially eyes), operators should minimize exposure to ultraviolet rays (contact time should be <1min);

9. Chemicals are prohibited from contacting this UV Accelerated Weathering Tester; (away from combustibles and explosives);

10. The wastewater discharge system of UV Accelerated Weathering Tester must be installed in place;

11. After each test, take out the sample and clean the UV Accelerated Weathering Tester liner;

12. After use, remember to put the plastic cover on. If there is dust, it should be removed in time to keep the appearance of the box clean and avoid dust from invading the box.

QINSUN is an excellent manufacturer and exporter, our UV accelerated weathering test equipment is sold all over the world, buy our equipment, we can provide accelerated weathering tester manual and free training. Our UV aging machine equipment has a favorable price, welcome to order!

2022-06-20 10:42