How to clean the components and connectors inside the xenon lamp aging tester?

The components and connectors inside the xenon lamp aging tester are high-precision electronic components that require special attention for protection. The following are some ways to clean the components and connectors inside the xenon aging tester:

1. close the test chamber: the test chamber should be closed and unplugged before cleaning to avoid damage to the test chamber circuit or danger to the operator.

2. Use a hair dryer: use a hair dryer to clean the dust and debris inside the test chamber. Should use a low-temperature, low-pressure hair dryer, and the air outlet to the test chamber internal components and connectors to blow away dust and debris.

3. Use anhydrous alcohol: For metal connectors and components, you can use anhydrous alcohol to clean them. Anhydrous alcohol should be poured on a clean cotton ball or cotton cloth first, and then gently wipe the components and connectors. It should be noted that the use of alcohol containing water or other chemical solvents should be avoided to avoid damage to the components and connectors. 4.

4. Use pure water: For plastic connectors and components, you can use pure water to clean. Pure water should first be poured on a clean cotton ball or cotton cloth, and then gently wipe the components and connectors. It should be noted that the use of water or other solutions containing chemicals should be avoided to avoid damage to components and connectors.

5. Prevent moisture from entering: When cleaning components and connectors, moisture should be avoided from entering the interior of the test chamber to avoid damage to the components and connectors. You can use absorbent paper towels or clean cotton balls to dry the moisture.

It is important to note that cleaning the components and connectors inside the xenon lamp aging tester requires careful handling to avoid damage to the tester or danger to the operator. If you are not sure how to clean the components and connectors inside the tester, you should consult the equipment manufacturer or a professional technician for advice.

2023-06-30 10:41